Видео

Is it posdible to open the boot from the inside when it's looked? I am going to camp in one 🙂 I saw on some video of a 95 that there was an emergency latch...

Was esr der Fehler?

Help - mine (2009 corsa d) knocks/creaks when I set off, break and steer past about 180 degrees. Nothing found on MOT, bushes and arms recently replaced. Sounds like it’s coming from the middle of the car maybe but unsure. Any suggestions as to what it could be would be appreciated

Just out of curiosity. Had it also damaged the ABS sensor. I only ask because that's why I'm changing it on my passat.

I wondering if you could take the switch from the other side and try that before purchasing a new one

Hi, Great explanation! Do you know if Vauxhall Astra cdti 17 plate would have the same setup? i've got a knock that the mechanic's can't figure out so want to give this ago if it is the same.

I have the same problem when my battery gone

If you pull forward the back seats it's a lot easier

Why is it that some brands of car like Mercedes and VW have a really satisfying "thunk" when you close a door and Ford's doors sound...crap?

Nice review def going to get one 😊

Thank you couldn't have done it without you. Never tried before . Had no tool for wiper one came off handy other not so. But sprayed WD 40 left overnight. Tip leave nut loose don't take off completely and put wiper position as if changing. Then wiggle while pulling. Worked.. also when clipping new rod to arm I cracked one plastic bit ( but still fine ) maybe use cloth or something when pressing. Also just check u have clipped on as I didn't do one right si fell off when put in car. But just took all out again clipped on heard snap ,put all back again Happy days. I when putting wipers back no harm putting towel or something on windscreen in case wiper snaps down again wiper on then nut loose then lay on windscreen . Thanks again ..

Would an old fuel filter make my engine malfunctioning warning come on when I accelerated ?

Good video & very informative. Gets straight to the point on what to do & not too much RUclips waffle like some do

You are a hero

can i just say this one of the best helpfull videos on youtube ,after much speculation with my daughters corsa mechanics telling me it was top mounts or play in the rack ,10 mins this morning and car is sorted ,thank you so much sir happy days

Hello sir I have got Corsa e 1.3 cdti and on turning ac on the rattling noise comes out what should I change ac pulley or all pulley thanks

Is there a way to clean condenser without taking off the front bumper?

Is it exactly the same procedure on the 1.8 petrol version?.

Thanks so much for this, recently inherited my Dad's old E-Class after he passed away, want to keep it on the road as long as I can without paying main dealer prices, videos like yours help keep the car community going.

What is the typical PSI required to start a car? I guess it would depend on the car? Mine is a ford focus 2007

Thank you very much for this!

The rear brake caliper of cr-v mk3(2007~2011) is sold in two types."excluding japan", "fit japan" I wonder what the difference between the two products is. I searched and found that the bolt specification of the caliper mount bracket is different, is the caliper part the same? I asked several places, but none of the sellers gave me a clear answer. What's the difference?

Thanks a lot, very informative additional informations as well.

my Corsa D SXi heater motor works but hardly any heat comes out 🤔

I will never buy ford car again, I drive now s max 2012,

Perfect 👌👌

Thanks alot for helping out!!! I was helping my friend replacing his left rear handbrake-cable. He has Haynes manual, but there was no mention of how to release the cable with the umbrella-lock under the mid-console. We owe you alot!! <3

Two points from my experience of doing this. One, there are three similar but different parts available. Two, be careful when fitting the indicator stalk, there is something which works the self cancelling. I missed it and now have do my own cancelling as I can't be bothered to strip it down again.

As a recent Picasso buyer with a countdown in progress, this has been very helpful indeed. No idea what possessed whoever signed off on that particular design, but at least I know what I’m up against now! Thank you.

Ty vm sir😁

Im at mine having a nightmare . Got the tool and it slips up off position under strain. Dont think its ever been done . Going to borrow one of those filter straps from a friend tomorrow. If that fails remove the whole housing to the bench vice to try other methods

Just had a window regulator ( wire rope ) fail today on my sons 66 plt corsa Sri and came across this video 👌👍 great help I managed to get window out and wedged in for now and I’ll look at replacing regulator later now I’ve seen this video great stuff 💪

Spot on. Thanks for taking the time to make the video. Super useful when replacing the handbrake release cable.

Thanks a lot for this video. I have the 2014 4-th gen. CR-V and it has the same engine like your 3-rd gen. here. I was misleaded by other videos showing the fuel filter under the rear seat... but then I watched your video and I realized it also fits to 2012 - 2014 2.2 i-dtec. And what a great engine it is! After changing the fuel filter runns again smooth like it used to run years ago...

Danke

Daer sir thanks !

You saved my life

Where is the fuse for the blowers? Thanks

Is this the same for a 2010?

how long does this job take from roll in to driving out ,,, roughly of course .

Great video. I am about to do it now I know what to do!

Great job👍👍

when using mine i often get promted to connect the vci with a usb cable, i'll see this prompt when doing various job's, for instance when i try to enter into the CAS module.Have you come across this, and if so were you able to gain that access, i attempted to many time with different usb ports on the otofix but always failed to 'get in', can you shed any light on this issue?

I used this tutorial for a Ford StreetKA (2004) but used RCA instead of AUX - slightly different way of getting to the CD player and a couple other differences i will list below for anyone interested: unplug the lights and power cable when removing radio unit take off the case on the other side (where the white plastic thingy sticks out, that side) few extra screws to get out the CD player as you’re coming from the other side but easy enough to figure out fed cable out the side next to the lamp plug because i’d already put the CD player back in but that last one was on me 😂 i used a RCA to aux cable instead of aux to aux, it was so fiddly soldering two grounds as i had to use the ground right between the L and R audio, used electrical tape to form a barrier between solders once cool so they didn’t bump about,

Thanks 👍🏻

what was the problem with the AC here? How did you diagnose it was the condenser failing?

subbed. thanks for knowledge.)))

Thanks for this. Very useful. ❤

How much should I put in??

Yes. This works! Greetings from Germany. Thank you very much